I see little bits of belt have shredded off one of the main belts. Is this normal? Should I do anything about it?
A1 Y-Belt tearing itself apart? : r/BambuLab
Bambu Lab X1 Carbon Review: Living In The Future
Ickiya GT2 Timing Belt 6mm x 5M,Wear Resistant Red Nylon Tooth Surfa,Upgrade Non-Slip Versionce for 3D Printer - Prusa i3 - Anet A8 A6 - Anycubic i3 Mega - Ender 3/5
AnkerMake M5C 3D Printer, 500 mm/s High-Speed Printing, All-Metal Hotend, Supports 300℃ Printing, Control via Multi-Device, Intuitive, 7×7 Auto-Leveling, 220×220×250 mm Print Volume : Industrial & Scientific
Failed to cut filament? Nothing wrong with the cutter. Please help. : r/BambuLab
A1 mini Introduction
Persistent 2mm VFAs on X-axis - Troubleshooting - Bambu Lab Community Forum
Belt tensioning procedure
Is this a belt issue? : r/BambuLab
Bambu lab x1 squeaking wear on top belt : r/BambuLab
Banding / Ringing type artifacts? - Bambu Lab X1-Carbon - Bambu Lab Community Forum
A1 Y-Belt tearing itself apart? : r/BambuLab
Banding / Ringing type artifacts? - #290 by adriangarside - Bambu Lab X1-Carbon - Bambu Lab Community Forum