Description Documents Description This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power then the PSS Shaft Seal does not require positive water feed. The PSS Shaft Seal can simply be "vented" or you can use this plug in place of the hose barb that's inserted into the carbon stator. "Burping" The PSS Shaft Seal You will also be required to "burp" the PSS Shaft Seal whenever there is air trapped inside. Simply pull back on the carbon stator, separating it from the stainless steel rotor. This will cause a quick mist of water to spray out. Important If your boat will exceed 10 knots under power then it is required that a positive water supply be plumbed to the PSS Shaft Seal for the purpose of lubricating and cooling
PYI Inc. PSS Type B Shaft Seal
PYI Inc. PSS Type B Shaft Seal
GW Ping TiSI Adaptors-PSS - The GolfWorks
PSS Shaft Seal 1 1/2 Shaft & 2 1/4 Shaft Log/Stern Tube, 02-112-214, PYI Inc : Industrial & Scientific
Buy Perko Gas Tank Vent with Swivel Elbow in USA Binnacle.com
Calaméo - Manuel Installation PSS SHAFT SEAL Type A
Answered) PSS Shaft seal vent hose or plug?
PSS Shaft Seal Install Instructions - PYI Inc.
1/2 in. Push-On Hose Barb x 1/2 in. Flare 37/45 Female Swivel, 150 PSI Max Pressure Rating 316 Stainless Steel Fitting
PYI Inc. PSS Type C Shaft Seal
PYI PSS PRO Shaft Seal, 1 1/2 Shaft, 2 1/2 - 2 5/8 Stern Tube Dia.
PYI PSS PRO Shaft Seals
Boat Propeller PSS Shaft Seal for 1-1/4 Prop Shaft
