Print failure - became spongy and stringy mid-print – How do I print this? ( Printing help) – Prusa3D Forum

I was printing a 73mm high model yesterday. The first 25mm went fine, but then the print became "spongy" and "stringy" as if not enough filament was b

Print failure - became spongy and stringy mid-print – How do I print this? (Printing help) – Prusa3D Forum

Print failure - became spongy and stringy mid-print – How do I print this? (Printing help) – Prusa3D Forum

Print failure - became spongy and stringy mid-print – How do I print this? (Printing help) – Prusa3D Forum

Print failure - became spongy and stringy mid-print – How do I print this? (Printing help) – Prusa3D Forum