Criteria to choose between clockwise and anticlockwise rotation of lines - Grasshopper - McNeel Forum

Hi guys, I come to seek some knowledge. I have a couple of lines pointing towards a center, and I need to rotate them so that they face the white direction. This rotation must be according to the least rotation possible. I was not able to think of an appropriate criteria to use. I thought about comparing Angle and Reflex angle, but it is not enough: In the picture you can see that both reflex angles (blue) are larger than the actual angle (red), but the line in the upper corner needs to be

Grasshopper Primer by M A S K - Issuu

Criteria to choose between clockwise and anticlockwise rotation of lines - Grasshopper - McNeel Forum

PDF) Grasshopper Primer V3-2 Антон Штанько

Speedo Katalóg 2020 Features Features Features-Polyester, 59% OFF

Full article: RoamFab: A Design Tool for Reconfiguring Parameterized Mechanisms to 3D Models With Structural Optimization

Toolpath strategies for the layman - Tutorials - Carbide 3D Community Site

PDF) Hangprinter for large scale additive manufacturing using fused particle fabrication with recycled plastic and continuous feeding

Toolpath strategies for the layman - Tutorials - Carbide 3D Community Site

Curve plane orientation - Grasshopper - McNeel Forum

Grasshopper Primer by M A S K - Issuu

Speedo Katalóg 2020 Features Features Features-Polyester, 59% OFF