P1p first layer is no longer as good as before - Troubleshooting - Bambu Lab Community Forum

Hey guys so since I did the last update to be at the latest firmware my first layer is lost it’s textured finish. I tried reverting to the previous firmware and still same issue. Support asked to to check the belt tension, recalibrate and manual level. Now I’m found calibration on the K value but the one value that looks best has problems with adhesion and one corner will lift lol, if I change it back to default it will print with no lift lol. Any other ideas from the group as to what I should t

Almost everything I print on the P1P warps - what am I doing wrong? : r/BambuLab

First layer not good on Bambulap P1P - Bambu Lab P1 Series - Bambu Lab Community Forum

Learning 3D printing - Langmuir Systems Forum

Bad printing quality with PETG - Troubleshooting - Bambu Lab Community Forum

New p1p first layer issues. : r/BambuLab

Releases · bambulab/BambuStudio

Best practice for printing logo in first layer (2 colors) - Bambu Studio - Bambu Lab Community Forum, g1 f1800

Hydra AMS for Bambu Lab X1 and P1P - Modification enables larger filament selection

Problem with first layer inspection - Bambu Lab X1 Series - Bambu Lab Community Forum

Bambu Lab - Filament Poop Bin - X1, X1C, P1P and P1S Remixed by harrypulvirenti - MakerWorld

Bambu Lab P1P Review - I Now Love Printing Terrain Again

Need Help with Bambulab P1P top Layer printing Issues (Pillow.) - Troubleshooting - Bambu Lab Community Forum

What changed? Not the smooth first layer it used to be, same file I've printed 50 times. P1P. : r/BambuLab

Has anyone had direct experience use JB Weld on metal to PLA

Best practice for printing logo in first layer (2 colors) - Bambu Studio - Bambu Lab Community Forum, g1 f1800