Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This
F1 front wing CFD thesis Inflation layer problem - Project Support - SimScale CAE Forum
Welcome To Your Digital Edition of and Sensor Technology: Tech Briefs, COMSOL News, Motion Design, PDF, Optics
Simulation Software – Page 8
Inflation does not follow edge of airfoil
Inflation Layer - Project Support - SimScale CAE Forum
Your Guide to Meshing Techniques for Efficient CFD Modeling
794 questions with answers in MESH
Inflation Layer - Project Support - SimScale CAE Forum
Mesh inflation layer not shown - Project Support - SimScale CAE Forum
Inflation Layer - Project Support - SimScale CAE Forum
Mesh inflation layer not shown - Project Support - SimScale CAE Forum
Inflation Layer - Project Support - SimScale CAE Forum