Hi guys, I’m having some problems splitting a mesh I have of a TPMS gyroid surface. It was created using millipede and then offset a small distance (not sure if that matters). When trying to split the mesh in 2 with an intersecting plane something odd happens. It does not split the mesh into 2 seperate meshes 1 above and 1 below the plane. It splits the mesh as shown in the picture below. Any insight on why this is happening would be greatly appreciated! here is the file with in
ModeLab Grasshopper Primer Third Edition by Gil Akos & Ronnie
McNeel Rhino Design, Model, Present, Analyze, Realize
Rhino/Grasshopper integration - BricsCAD BIM
ModeLab Grasshopper Primer Third Edition by Gil Akos & Ronnie
Grasshopper 101: Data Lists, #07 Shortest List
Mesh split losing part of mesh? - Grasshopper - McNeel Forum
Installing Rhino • parametric by design
Rhino/Grasshopper integration - BricsCAD BIM
PDF) Grasshopper Primer V3-2 Антон Штанько
Mesh split - Grasshopper - McNeel Forum
Mesh Split Problem with disjointed meshes - Grasshopper - McNeel Forum
Pufferfish Food4Rhino
Algorithmic Modelling with Grasshopper by Mohamad Khabazi by Pablo
